GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » Retrofit multifunction turn signal switch
Retrofit multifunction turn signal switch [message #103758] Fri, 22 October 2010 08:06 Go to previous message
RF_Burns is currently offline  RF_Burns   Canada
Messages: 2277
Registered: June 2008
Location: S. Ontario, Canada
Karma:
Senior Member
Anyone found a multifunction turn signal switch and arm that will fit into the original steering column?

Or an aftermarket one that fits?

This site has lots of arms listed:
http://monsterautoparts.com/OLDSMOBILE/Toronado/oldsmobile_toronado_steering_column_par.htm

Or maybe arm and switch in one that fits like this one:
http://monsterautoparts.com/CHEVROLET/EXPRESS%20VAN/D6240C.jpg

I know I may have to make up some kind of interface to read a resistor ladder or decode a BCD switch but nothing that a small PLC or a $2.00 microprocessor can't handle.

I just want to avoid the whole column exchange.

Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Need Advice Removing Ignition Lock Without Key
Next Topic: [GMCnet] parking brake
Goto Forum:
  


Current Time: Fri Sep 27 14:44:45 CDT 2024

Total time taken to generate the page: 0.00849 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software