| |
2521 Search Results Found |
| 1 |
Forum: GMCnet «»
Posted on: Thu, 11 August 2011 09:14 «»
By: James Hupy
Re: [GMCnet] 78 Royale For Sale
…Stick, You can value unsolicited advice at what you paid for it, and I won't
be offended. But, if I were in a situation similar to yours, I would not be
too hasty to sell the GMC unless you are at the point where it comes to
feeding the wife and kids or …
|
| 2 |
Forum: GMCnet «»
Posted on: Tue, 09 August 2011 17:04 «»
By: kwharland
Re: [GMCnet] Quadrajet problems
…went ahead and tested the fuel selector solenoid and the fuel pump and both check out well.
What I've done most recently is confirm that the vacuum and mechanical advances are both operating within spec, then I adjusted the initial from 8 to 12 degree …
|
| 3 |
Forum: GMCnet «»
Posted on: Mon, 08 August 2011 19:00 «»
By: bryant374
Re: [GMCnet] Greenberg's GMC pin
…Re: [GMCnet] Greenberg's GMC pin
Mon, 08 August 2011 18:06
Robert Mueller
Bill,
I was at DuQuoin when JR presented your son with the buckle; I have NEVER
seen a bigger smile on anybody anytime anywhere!
Regards,
Rob M.
Sydney…
|
| 4 |
Forum: GMCnet «»
Posted on: Mon, 08 August 2011 18:55 «»
By: Ken Burton
Re: [GMCnet] onan jumpers part 2
…
[/quote]
Ken,
Just got off the phone with Dinosaur Electronics discussing results of testing my burned Onan Circuit boards.
They say a 56 ohm resistor has burned on both the boards I sent in. They also say a number of boards had the …
|
| 5 |
Forum: GMCnet «»
Posted on: Mon, 08 August 2011 17:06 «»
By: USAussie
Re: [GMCnet] Greenberg's GMC pin
…Bill,
I was at DuQuoin when JR presented your son with the buckle; I have NEVER
seen a bigger smile on anybody anytime anywhere!
Regards,
Rob M.
Sydney, Australia
AUS '75 Avion-The Blue Streak TZE365V100428
USA '75 Avion-Double Trouble TZE365V100426…
|
| 6 |
Forum: GMCnet «»
Posted on: Mon, 08 August 2011 15:37 «»
By: gmcrv1
Re: [GMCnet] Cover windshield fog
…may not make Goshen, but I could cut a lot of pieces on my plotter and
send them up for those that want them.. I also have an almost unlimited
supply of high density waterproof foam that is the same material that people
are using on the heater/AC doors…
|
| 7 |
Forum: GMCnet «»
Posted on: Mon, 08 August 2011 14:24 «»
By: carguy
Re: [GMCnet] Greenberg's GMC pin
…Greenberg wrote:
BTW, I am thinking of putting my treasured GMC Belt Buckle on ebay soon. I really have mixed emotions about this as it was a special presentation by JR Slaten but... neither of my sons are interested in it and I can't take it with me. …
|
| 8 |
Forum: GMCnet «»
Posted on: Sun, 07 August 2011 17:11 «»
By: Steven Ferguson
Re: [GMCnet] Stupid AC, 20psi, 120psi...73degrees
…Keith,
Are you sure your engine coolant supply hoses for the heater side of the
HVAC are completely isolated? Many folks have had issues with poor flap
sealing or a HW shut off valve leaking or not working at all.
I have to say that I never could get …
|
| 9 |
Forum: GMCnet «»
Posted on: Sat, 06 August 2011 21:11 «»
By: emerystora
Re: [GMCnet] Stupid AC, 20psi, 120psi...73degrees
… John
I have an 18,000 BTU aux evaporator with it's own expansion valve and
it stii works best at 20 psi. And I filled with slightly less than 3
cans.
Emery Stora
On Aug 6, 2011, at 5:38 PM, John Sharpe <johnasharpe@earthlink.net>
…
|
| 10 |
Forum: GMCnet «»
Posted on: Sat, 06 August 2011 18:38 «»
By: John Sharpe
Re: Stupid AC, 20psi, 120psi...73degrees
…
If you are trying for 19psi I assume you are using Duracool. Since you have two expansion valves you are using more volume of refrigerant that a stock system. Perhaps the low side needs to be a little higher. Juice it to 25 and see what the …
|
| 11 |
Forum: GMCnet «»
Posted on: Sat, 06 August 2011 15:08 «»
By: Keith V
Stupid AC, 20psi, 120psi...73degrees
…from this thread;
http://gmc.mybirdfeeder.net/GMCforum/index.php?t=msg&th=18173&start=0&rid=1431
Or for the Email crowd subject is; More AC questions....
so I bought real (well harbor freight) AC gauges.
* Low side 19 psi
* High …
|
| 12 |
Forum: GMCnet «»
Posted on: Thu, 04 August 2011 09:16 «»
By: USAussie
Re: [GMCnet] Carb solutions
…Tom,
I didn't see where you mentioned which engine you have in your GMC, is it a
455 or 403. The carbs are NOT the same!
Also I did not see where you mentioned where you lived; if you live in
California and your coach is registered there the carb has a …
|
| 13 |
Forum: GMCnet «»
Posted on: Wed, 03 August 2011 19:03 «»
By: C Boyd
Re: Carb solutions
Sir: there is a carb on the swap meet page.
http://gmc.mybirdfeeder.net/GMCforum/index.php?t=msg&th=18191&start=0&rid=975
|
| 14 |
Forum: GMCnet «»
Posted on: Wed, 03 August 2011 18:21 «»
By: tgeiger
Carb solutions
…Ok, I got another phone call from my mechanic. He said he had replaced the hard fuel line up to the carb and now he believes he has stripped out the connection on the front of the carb, so now we have a fuel leak on that connection. He says he can't …
|
| 15 |
Forum: GMCnet «»
Posted on: Sun, 31 July 2011 20:12 «»
By: James Hupy
Re: [GMCnet] I probably need an Onan Flywheel
…Ken, don't use that flywheel if it is cracked and welded through the taper.
Check with the Sirum's in Okechobee, Fl. Jeff knows his stuff on them. He
helped me on rewiring the brush holders on my 6K and even took digital pix
and emailed them to me. Big …
|
| 16 |
Forum: GMCnet «»
Posted on: Sun, 31 July 2011 01:08 «»
By: Ken Burton
I probably need an Onan Flywheel
…has been a project that never ends. First the ignition quit. A screw cam loose and the pickup hit he fly wheel. Then the starter quit. I had it rebuilt. In the process of fixing the starter I found the gear all chewed up. I discovered a PO home …
|
| 17 |
Forum: GMCnet «»
Posted on: Sat, 30 July 2011 09:23 «»
By: Ken Henderson
Re: [GMCnet] Birchaven Propane capacity
…Johnny,
If you have the tank Coachmen installed, try to keep burning gas after
the gage shows E, 'cause that tank really is 19+ g. capacity. They
need to be emptied every few years, at least, to get rid of the
accumulated additives. In fact the odor …
|
| 18 |
Forum: GMCnet «»
Posted on: Fri, 29 July 2011 13:46 «»
By: WD0AFQ
Re: Cloging my Email
Ok, if you just use the forum, http://gmc.mybirdfeeder.net/GMCforum/index.php?t=i&cat=1&rid=626
and turn off the email, no more clogged mailbox. It is just a personal preference.
Dan
|
| 19 |
Forum: GMCnet «»
Posted on: Wed, 20 July 2011 13:14 «»
By: hnielsen2
Re: [GMCnet] Venting of Refrigerants
…----- Original Message -----
From: "A." <markbb1@netzero.com>
To: <gmclist@temp.gmcnet.org>
Sent: Wednesday, July 20, 2011 9:33 AM
Subject: Re: [GMCnet] Venting of Refrigerants
>
>
> hnielsen2 wrote on Tue, 19 …
|
| 20 |
Forum: GMCnet «»
Posted on: Wed, 20 July 2011 11:33 «»
By: A Hamilto
Re: [GMCnet] Venting of Refrigerants
Seems we need to switch to decaf. Might be a good idea to get the blood pressure checked as well.
|
GMCforum
Search
Help
Register
Login
Home