GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » Turn signal replacement
Re: Turn signal replacement [message #362907 is a reply to message #362901] Thu, 18 March 2021 20:10 Go to previous messageGo to previous message
RF_Burns is currently offline  RF_Burns   Canada
Messages: 2277
Registered: June 2008
Location: S. Ontario, Canada
Karma:
Senior Member
A good set of instructions for dismantling the steering column is here:

https://www.gmcmi.com/wp-content/uploads/2013/02/Steering-column-rebuild.pdf

Once you upgrade the turn-signal switch, the crisp operation of the new switch makes it feel like you are driving a new vehicle! Very Happy

FYI the switch with the extra contacts for turning lights is less expensive!

Fishing the cable down inside the column is not too bad. Use the old cable to pull a fish wire up inside the column. Then use that wire to pull the new cable assembly back down.

Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Question for a "friend"
Next Topic: Seeking Battery Boost Visor Sleeve
Goto Forum:
  


Current Time: Sun May 26 11:45:47 CDT 2024

Total time taken to generate the page: 1.96233 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software