Re: [GMCnet] Bearing Puller Atlanta [message #329353 is a reply to message #329330] |
Tue, 20 February 2018 22:43 |
andyg
Messages: 12 Registered: January 2011 Location: Atlanta, GA
Karma:
|
Junior Member |
|
|
Hey Guys,
Appreciate all the help. Borrowed the tool from Patrick F. I think his is just for installing the bearings. Didn't have the hardware to pull the bearings.
Anyhow, we pulled the hub/knuckle assembly off my other coach and installed it. Test drive felt good so we'll go with that for the short term. Still need to get the right tool and get the bearing out of the original hub and and the fresh set reinstalled.
Haven't tried getting a generic bearing puller from a parts house, but that could be an options. If that doesn't work, perhaps I can get in line for the loaner Billy has.
Thanks again all!
Andy Grimes
Atlanta, GA
"The Pickle" 1975 GMC Palm Beach
ultimateculinary.com
|
|
|