GMCforum: GMCnet » [GMCnet] Figured out how to count water pump impeller blades while pump is installed on engine

Home » Public Forums » GMCnet » [GMCnet] Figured out how to count water pump impeller blades while pump is installed on engine

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Figured out how to count water pump impeller blades while pump is installed on engine [message #329006]

Fri, 09 February 2018 23:54

BobDunahugh

Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA

Karma:

Senior Member

I'd really like to make sure that my engine water pump is correct. Pulling it out to check isn't on my list of favorite things to do. Was looking at a new water pump. If I pull the 3/4" hose off the top of the water pump housing. My inspection camera can be put down that water port to count the impellers as I rotate the shaft. Bob Dunahugh
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

[Message index]

		[GMCnet] Figured out how to count water pump impeller blades while pump is installed on engine By: BobDunahugh on Fri, 09 February 2018 23:54
		Re: [GMCnet] Figured out how to count water pump impeller blades while pump is installed on engine By: Ken Henderson on Sat, 10 February 2018 06:05
		Re: [GMCnet] Figured out how to count water pump impeller blades while pump is installed on engine By: BobDunahugh on Sat, 10 February 2018 10:35
		Re: [GMCnet] Figured out how to count water pump impeller blades while pump is installed on engine By: Tom Lins on Sat, 10 February 2018 12:37

Previous Topic:	[GMCnet] GM net] Figured out how to count water pump impeller
Next Topic:	[GMCnet] GMC CRV Toad Q.

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Apr 20 00:20:46 CDT 2024

Total time taken to generate the page: 0.01101 seconds