Re: [GMCnet] GMC CRV Toad Q. [message #329007 is a reply to message #329004] |
Sat, 10 February 2018 05:55 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
Jim,
I'm talking about the plastic shields down each side underneath, outboard
of the centerline where a driveshaft would be on an AWD, and outside the
exhaust system. That is apparently the same as you've described -- but
only on the left side, where there are lines, hoses, and wires passing, and
the gas tank is visible. Just seems like a lot of room for a little bit of
stuff.
The big mystery is the right side where I see nothing passing into nor out
of the long "box".
I haven't taken either of the covers off yet, and have replaced the CRV on
the with the GMC, making photos difficult for a few days.
Thanks for any ideas you have.
Ken H.
On Fri, Feb 9, 2018 at 11:28 PM, Jim DeMellia
wrote:
> Ken. I’m a autobody Technician and I’m trying to figure what you are
> taking off your CRV. Most CRVS have two long plastic covers on either side
> held in by varying clips and some 10mm bolts. Those usually cover all your
> lower break lines and resonators and fuel lines and gas tank and should be
> put back on to limit road debris from damaging all those components. If you
> could snag a picture and send it to me I could help you out a little
> better. My number is (six0three)two35-one57six.
>
> Sent from my iPhone
>
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|