Re: [GMCnet] Lots of exhaust questions [message #328978 is a reply to message #328975] |
Fri, 09 February 2018 08:31 |
Keith V
Messages: 2337 Registered: March 2008 Location: Mounds View,MN
Karma:
|
Senior Member |
|
|
I'm a cheap DIYer. I just went to Car Quest bought some 3" aluminized tubing, two flex couplings and some mandrel bends.
I have a royale so that meant a rear mounted mufller would require cutting down a flowmaster 80.
I used a combination of welding and band clamps to put it all together.
http://www.gmcmhphotos.com/photos/g5477-new-exhaust.html
________________________________
From: Gmclist on behalf of Johnny Bridges via Gmclist
Sent: Friday, February 9, 2018 8:12:30 AM
To: gmclist@list.gmcnet.org
Cc: Johnny Bridges
Subject: Re: [GMCnet] Lots of exhaust questions
I've a local muffler shop that an ol' gray bearded fart runs. He can bend up and weld in stainless or aluminized pretty much anything to anything
have a look at the Ratrod plumbing sometime. Reasonably priced, leakfree, and it doesn't rattle. I'd either find such a shop or buy Applied's
prebent stuff in stainless. If the latter, I'd get it under properly where it doesn't leak or rattle. and then find a good welder who knows what
she's doind to weld all the seams. My experience with long connected pipes wants flanged or welded jubctions.
--johnny
--
76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
"I forgive them all, save those who hurt the dogs. They must answer to me in hell" - ol Andy, paraphrased
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Keith Vasilakes
Mounds View. MN
75 ex Royale GMC
ask me about MicroLevel
Cell, 763-732-3419
My427v8@hotmail.com
|
|
|