GMCforum: GMCnet » Overbore Size

Home » Public Forums » GMCnet » Overbore Size (Related to my engine failure)

Show: Today's Messages :: Polls :: Message Navigator

Re: Overbore Size [message #328553 is a reply to message #328505]

Tue, 23 January 2018 17:26

JohnL455

Messages: 4447
Registered: October 2006
Location: Woodstock, IL

Karma:

Senior Member

With the amount of work it takes to R and R an engine in a TZE, I would not want a + .060 in mine when pulling a long long grade over 6%.
I would put a meatier block in the MH and use that one in a Cutlass, 442, or 98 where long term heat loads are much lower.

John Lebetski
Woodstock, IL
77 Eleganza II

Report message to a moderator

[Message index]

		Overbore Size By: Carl S. on Mon, 22 January 2018 14:12
		Re: [GMCnet] Overbore Size By: James Hupy on Mon, 22 January 2018 14:19
		Re: [GMCnet] Overbore Size By: James Hupy on Tue, 23 January 2018 15:58
		Re: [GMCnet] Overbore Size By: BobDunahugh on Tue, 23 January 2018 16:18
		Re: [GMCnet] Overbore Size By: James Hupy on Tue, 23 January 2018 16:23
		Re: [GMCnet] Overbore Size By: James Hupy on Tue, 23 January 2018 18:06
		Re: Overbore Size By: kingd on Tue, 23 January 2018 10:31
		Re: [GMCnet] Overbore Size By: powwerjon on Tue, 23 January 2018 10:52
		Re: [GMCnet] Overbore Size By: jimk on Tue, 23 January 2018 11:18
		Re: Overbore Size By: JohnL455 on Tue, 23 January 2018 17:26
		Re: Overbore Size By: JohnL455 on Tue, 23 January 2018 20:47

Previous Topic:	replacement interior window trim
Next Topic:	[GMCnet] New stuff being made??

Goto Forum:

-=] Back to Top [=-

Current Time: Thu May 09 21:00:15 CDT 2024

Total time taken to generate the page: 0.01523 seconds