GMCforum: GMCnet » How Do I..??

Home » Public Forums » GMCnet » How Do I..??

Show: Today's Messages :: Polls :: Message Navigator

Re: How Do I..?? [message #328491 is a reply to message #328447]

Mon, 22 January 2018 08:55

jhbridges

Messages: 8412
Registered: May 2011
Location: Braselton ga

Karma:

Senior Member

Well, the floor is a bit 3D. I'm going to try the hole saw with the drill bit reversed so it doesn't move sideways when the saw is cutting only one side. The air powered and the drill driven nibblers are the only ones rated to cut more than 18Ga. and I suspect the floor is thicker than that. They're a bit much for a one - time job.

--johnny.

Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell

[Updated on: Mon, 22 January 2018 09:07]

Report message to a moderator

[Message index]

		How Do I..?? By: jhbridges on Sun, 21 January 2018 13:43
		Re: [GMCnet] How Do I..?? By: emerystora on Sun, 21 January 2018 14:21
		Re: [GMCnet] How Do I..?? By: Bullitthead on Sun, 21 January 2018 15:07
		Re: [GMCnet] How Do I..?? By: Bullitthead on Sun, 21 January 2018 15:13
		Re: [GMCnet] How Do I..?? By: Marsh Wilkes on Sun, 21 January 2018 18:48
		Re: How Do I..?? By: jhbridges on Mon, 22 January 2018 08:55

Previous Topic:	[GMCnet] Electric fuel pump for AOnan genset
Next Topic:	Onan (4K) Priming / Fuel Pump Questions...

Goto Forum:

-=] Back to Top [=-

Current Time: Wed May 15 01:05:31 CDT 2024

Total time taken to generate the page: 0.01117 seconds