Re: [GMCnet] How Do I..?? [message #328469 is a reply to message #328447] |
Sun, 21 January 2018 18:48 |
Marsh Wilkes
Messages: 155 Registered: January 2004
Karma:
|
Senior Member |
|
|
Hi Johnny,
https://canibbletools.com/
I got one of these, an incredible tool, fast, easy, leaves smooth edges
etc.,
don't know how I got along without it all these years!! You can also get
cheap chinese ones.
Marsh (rarely post) Wilkes
-----Original Message-----
From: Johnny Bridges via Gmclist
Sent: Sunday, January 21, 2018 2:43 PM
To: gmclist@list.gmcnet.org
Cc: Johnny Bridges
Subject: [GMCnet] How Do I..??
I need to cut about a 3" hole in the ratrod floor. Behind this hole is the
clutch slave, including its bleeder which I need to get to. The nipple
currently on it is broken off to clear. In what way might I safely cut the
floodboard without hacking up the essentials behind it.
--johnny
--
76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
"I forgive them all, save those who hurt the dogs. They must answer to me
in hell" - ol Andy, paraphrased
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
---
This email has been checked for viruses by AVG.
http://www.avg.com
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|