Home » Public Forums » GMCnet » hei cap orientation
Re: [GMCnet] hei cap orientation [message #328413 is a reply to message #328410] |
Sat, 20 January 2018 18:42 |
cadelec
Messages: 303 Registered: September 2011 Location: Brisbane Australia
Karma:
|
Senior Member |
|
|
hi jim this is a turbo city EFI setup i have attached links below relating to the documentation i have got
unfortunatly turbo city have stopped support so i am trying to work out what i have got and how it works
http://www.gmcmhphotos.com/photos/showfull.php?photo=64478
http://www.gmcmhphotos.com/photos/showfull.php?photo=64477
jimk wrote on Sun, 21 January 2018 09:21If it has a 4 pin module, there is NO distributor timig control by the ECM.
On Sat, Jan 20, 2018 at 2:08 PM, Trevor Pordage
wrote:
> thanks jim i have a turbo city EFI system which is no lunger supported i
> do have a little bit of documentation from the PO but not much. it does say
> in one part that there is an ignition module but this only has 4 wires but
> i assume it controls all the timing.
>
> interesting about the VW distributor
>
> Rob and Ken Thanks also the wires are infact in the same orientation and
> match up with the firing order i will leave it the way it is i just need to
> make note not to follow the numbers on the retaining ring
>
> thanks bruce that is the kind of diagnosis advice i need today i will try
> and do that and maybe drain the tanks and put in new fuel
>
>
> --
> Trevor
> Brisbane Australia
> Siesta Koala 76 Edgemont (old Bobby Moores)
> 71 Cadillac Eldo Convert
> 58 Cadillac Eldorado Brougham Project
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Trevor
Brisbane Australia
Siesta Koala 76 Edgemont (old Bobby Moores)
71 Cadillac Eldo Convert
58 Cadillac Eldorado Brougham Project
|
|
|
|
|
hei cap orientation
By: cadelec on Thu, 18 January 2018 23:10
|
|
|
Re: hei cap orientation
|
|
|
Re: hei cap orientation
By: cadelec on Fri, 19 January 2018 16:18
|
|
|
Re: hei cap orientation
|
|
|
Re: hei cap orientation
|
|
|
Re: [GMCnet] hei cap orientation
By: ljdavick on Fri, 19 January 2018 14:31
|
|
|
Re: [GMCnet] hei cap orientation
|
|
|
Re: [GMCnet] hei cap orientation
|
|
|
Re: [GMCnet] hei cap orientation
By: cadelec on Fri, 19 January 2018 23:54
|
|
|
Re: [GMCnet] hei cap orientation
By: USAussie on Sat, 20 January 2018 04:02
|
|
|
Re: [GMCnet] hei cap orientation
|
|
|
Re: hei cap orientation
By: JohnL455 on Fri, 19 January 2018 09:04
|
|
|
Re: hei cap orientation
By: JohnL455 on Fri, 19 January 2018 09:05
|
|
|
Re: [GMCnet] hei cap orientation
By: jimk on Fri, 19 January 2018 13:46
|
|
|
Re: hei cap orientation
|
|
|
Re: hei cap orientation
By: RF_Burns on Sat, 20 January 2018 11:42
|
|
|
Re: hei cap orientation
By: cadelec on Sat, 20 January 2018 16:08
|
|
|
Re: [GMCnet] hei cap orientation
By: jimk on Sat, 20 January 2018 17:21
|
|
|
Re: [GMCnet] hei cap orientation
By: cadelec on Sat, 20 January 2018 18:42
|
|
|
Re: [GMCnet] hei cap orientation
By: cadelec on Sat, 20 January 2018 19:40
|
|
|
Re: hei cap orientation
By: RF_Burns on Sat, 20 January 2018 20:18
|
|
|
Re: hei cap orientation
By: RF_Burns on Sat, 20 January 2018 20:53
|
|
|
Re: [GMCnet] hei cap orientation
By: jimk on Sun, 21 January 2018 13:30
|
|
|
Re: hei cap orientation
By: cadelec on Tue, 23 January 2018 01:19
|
Goto Forum:
Current Time: Mon May 13 19:29:48 CDT 2024
Total time taken to generate the page: 0.00883 seconds
|