| Re: [GMCnet] hei cap orientation [message #328410 is a reply to message #328403] |
Sat, 20 January 2018 17:21   |
jimk
Messages: 6734
Registered: July 2006
Location: Belmont, CA
Karma:
|
Senior Member |
|
|
If it has a 4 pin module, there is NO distributor timig control by the ECM.
On Sat, Jan 20, 2018 at 2:08 PM, Trevor Pordage
wrote:
> thanks jim i have a turbo city EFI system which is no lunger supported i
> do have a little bit of documentation from the PO but not much. it does say
> in one part that there is an ignition module but this only has 4 wires but
> i assume it controls all the timing.
>
> interesting about the VW distributor
>
> Rob and Ken Thanks also the wires are infact in the same orientation and
> match up with the firing order i will leave it the way it is i just need to
> make note not to follow the numbers on the retaining ring
>
> thanks bruce that is the kind of diagnosis advice i need today i will try
> and do that and maybe drain the tanks and put in new fuel
>
>
> --
> Trevor
> Brisbane Australia
> Siesta Koala 76 Edgemont (old Bobby Moores)
> 71 Cadillac Eldo Convert
> 58 Cadillac Eldorado Brougham Project
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
