GMCforum: GMCnet » hei cap orientation

Home » Public Forums » GMCnet » hei cap orientation

Show: Today's Messages :: Polls :: Message Navigator

Re: hei cap orientation [message #328403 is a reply to message #328401]

Sat, 20 January 2018 16:08

cadelec

Messages: 303
Registered: September 2011
Location: Brisbane Australia

Karma:

Senior Member

thanks jim i have a turbo city EFI system which is no lunger supported i do have a little bit of documentation from the PO but not much. it does say in one part that there is an ignition module but this only has 4 wires but i assume it controls all the timing.

interesting about the VW distributor

Rob and Ken Thanks also the wires are infact in the same orientation and match up with the firing order i will leave it the way it is i just need to make note not to follow the numbers on the retaining ring

thanks bruce that is the kind of diagnosis advice i need today i will try and do that and maybe drain the tanks and put in new fuel

Trevor Brisbane Australia Siesta Koala 76 Edgemont (old Bobby Moores) 71 Cadillac Eldo Convert 58 Cadillac Eldorado Brougham Project

Report message to a moderator

[Message index]

		hei cap orientation By: cadelec on Thu, 18 January 2018 23:10
		Re: hei cap orientation By: Ken Burton on Fri, 19 January 2018 04:25
		Re: hei cap orientation By: cadelec on Fri, 19 January 2018 16:18
		Re: hei cap orientation By: Ken Burton on Fri, 19 January 2018 17:16
		Re: hei cap orientation By: Matt Colie on Fri, 19 January 2018 07:24
		Re: [GMCnet] hei cap orientation By: ljdavick on Fri, 19 January 2018 14:31
		Re: [GMCnet] hei cap orientation By: Ken Henderson on Fri, 19 January 2018 07:34
		Re: [GMCnet] hei cap orientation By: James Hupy on Fri, 19 January 2018 17:39
		Re: [GMCnet] hei cap orientation By: cadelec on Fri, 19 January 2018 23:54
		Re: [GMCnet] hei cap orientation By: USAussie on Sat, 20 January 2018 04:02
		Re: [GMCnet] hei cap orientation By: James Hupy on Sat, 20 January 2018 10:48
		Re: hei cap orientation By: JohnL455 on Fri, 19 January 2018 09:04
		Re: hei cap orientation By: JohnL455 on Fri, 19 January 2018 09:05
		Re: [GMCnet] hei cap orientation By: jimk on Fri, 19 January 2018 13:46
		Re: hei cap orientation By: Ken Burton on Sat, 20 January 2018 11:00
		Re: hei cap orientation By: RF_Burns on Sat, 20 January 2018 11:42
		Re: hei cap orientation By: cadelec on Sat, 20 January 2018 16:08
		Re: [GMCnet] hei cap orientation By: jimk on Sat, 20 January 2018 17:21
		Re: [GMCnet] hei cap orientation By: cadelec on Sat, 20 January 2018 18:42
		Re: [GMCnet] hei cap orientation By: cadelec on Sat, 20 January 2018 19:40
		Re: hei cap orientation By: RF_Burns on Sat, 20 January 2018 20:18
		Re: hei cap orientation By: RF_Burns on Sat, 20 January 2018 20:53
		Re: [GMCnet] hei cap orientation By: jimk on Sun, 21 January 2018 13:30
		Re: hei cap orientation By: cadelec on Tue, 23 January 2018 01:19

Previous Topic:	[GMCnet] Ken. Came we have new windshields installed in Amana Iowa in September?
Next Topic:	Re: [GMCnet] Ken. Can we have new windshields installed in Amana Iowa in September.

Goto Forum:

-=] Back to Top [=-

Current Time: Tue May 14 05:34:57 CDT 2024

Total time taken to generate the page: 0.05714 seconds