GMCforum: GMCnet » hei cap orientation

Home » Public Forums » GMCnet » hei cap orientation

Show: Today's Messages :: Polls :: Message Navigator

Re: hei cap orientation [message #328382 is a reply to message #328379]

Fri, 19 January 2018 07:24

Matt Colie

Messages: 8547
Registered: March 2007
Location: S.E. Michigan

Karma:

Senior Member

cadelec wrote on Fri, 19 January 2018 00:10

i am trying to get my coach running after sitting for about 4 years. it is idling rough and backfires under load.has hei dist and has been converted to throttlebody fuel injection. i was going to pull the plugs and do a compression test but noticed that the cap is 180 degrees out. it was obviously working ok when i bought it and i havnt touched it since getting it here . just would like to know the reason for this. i assume this is because it is a dist. out of a car and the cap has not been notched to spin 180 degrees. am i correct

Trevor,

While you are under there, check for a 5-7 cross. This does not have to be wires switched. If 5 and 7 are too close together, this can happen.

Matt

Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit

Report message to a moderator

[Message index]

		hei cap orientation By: cadelec on Thu, 18 January 2018 23:10
		Re: hei cap orientation By: Ken Burton on Fri, 19 January 2018 04:25
		Re: hei cap orientation By: cadelec on Fri, 19 January 2018 16:18
		Re: hei cap orientation By: Ken Burton on Fri, 19 January 2018 17:16
		Re: hei cap orientation By: Matt Colie on Fri, 19 January 2018 07:24
		Re: [GMCnet] hei cap orientation By: ljdavick on Fri, 19 January 2018 14:31
		Re: [GMCnet] hei cap orientation By: Ken Henderson on Fri, 19 January 2018 07:34
		Re: [GMCnet] hei cap orientation By: James Hupy on Fri, 19 January 2018 17:39
		Re: [GMCnet] hei cap orientation By: cadelec on Fri, 19 January 2018 23:54
		Re: [GMCnet] hei cap orientation By: USAussie on Sat, 20 January 2018 04:02
		Re: [GMCnet] hei cap orientation By: James Hupy on Sat, 20 January 2018 10:48
		Re: hei cap orientation By: JohnL455 on Fri, 19 January 2018 09:04
		Re: hei cap orientation By: JohnL455 on Fri, 19 January 2018 09:05
		Re: [GMCnet] hei cap orientation By: jimk on Fri, 19 January 2018 13:46
		Re: hei cap orientation By: Ken Burton on Sat, 20 January 2018 11:00
		Re: hei cap orientation By: RF_Burns on Sat, 20 January 2018 11:42
		Re: hei cap orientation By: cadelec on Sat, 20 January 2018 16:08
		Re: [GMCnet] hei cap orientation By: jimk on Sat, 20 January 2018 17:21
		Re: [GMCnet] hei cap orientation By: cadelec on Sat, 20 January 2018 18:42
		Re: [GMCnet] hei cap orientation By: cadelec on Sat, 20 January 2018 19:40
		Re: hei cap orientation By: RF_Burns on Sat, 20 January 2018 20:18
		Re: hei cap orientation By: RF_Burns on Sat, 20 January 2018 20:53
		Re: [GMCnet] hei cap orientation By: jimk on Sun, 21 January 2018 13:30
		Re: hei cap orientation By: cadelec on Tue, 23 January 2018 01:19

Previous Topic:	[GMCnet] Ken. Came we have new windshields installed in Amana Iowa in September?
Next Topic:	Re: [GMCnet] Ken. Can we have new windshields installed in Amana Iowa in September.

Goto Forum:

-=] Back to Top [=-

Current Time: Tue May 14 05:37:44 CDT 2024

Total time taken to generate the page: 0.02004 seconds