GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Head gasket leak?
Re: Head gasket leak? [message #328395 is a reply to message #328252] Fri, 19 January 2018 21:46 Go to previous messageGo to previous message
Jimmy_Bonez is currently offline  Jimmy_Bonez   United States
Messages: 105
Registered: September 2017
Location: NH
Karma:
Senior Member
Once again guys a day late and dollar short. Didn't stick around Fredericksburg very long. As much as we aren't on a timeline we still have places we are supposed to be stopping at certain times. So cliff notes. I tried to call Dick Patterson to no avail, not a big deal at least I have his number for future issues. I got a hold of a buddy back home old gear head. He reiterated what you guys said, these motors are going to spit at you growl and sometimes question your sanity but if it sounds like it's running good it probably is and she sounds great when running. . I tightened all the valve cover bolts which were all loose. I crawled under and tightened what I could get at on the oil pan which were also loose and then the tranny cover bolts which were also loose. Seemed to help a little with the "drips". Little bit of oil at the base of the distributor cap as well after I cleaned the engine up. Still seem to get some extra dripping in the oil filter area, just above it from what I can see. Also oil pressure gauge shows just above half while driving and when idling drops down to low. Going to dig out the original manual about the oil pressure which I vaguely remember being in there. Thanks again guys

Jim DeMellia and Jen Radefeld and our cat Ickis NH natives 1975 GMC “Palm Beach” ,455, her names Linda Full time RVers exploring the beautiful and unusual parts of the country.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Electric motor converision
Next Topic: Re: [GMCnet] GMCNet Proportional Valve
Goto Forum:
  


Current Time: Wed May 15 10:37:03 CDT 2024

Total time taken to generate the page: 0.01991 seconds