Re: [GMCnet] JC-4 vacuum pump observations [message #327889 is a reply to message #327871] |
Sat, 06 January 2018 11:59 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
Bruce,
Pete Pappas, ex-GMCer modified JC4's for better vacuum. He sent me
instructions which I'll continue to hunt. The mid involved an added screw
threaded into the top of the housing and ball point pen spring, or
similar. Seemed to me like a little too much of a kludge for me so I never
tried it.
Ken
On Sat, Jan 6, 2018 at 10:50 AM, Bruce Hislop wrote:
> After reading a post about the JC-4 vacuum pump capabilities, I decided to
> test mine. Mine pumps down to 9" of vacuum and restarts at 6". That is
> too low for my liking.
>
> I was sure I read where someone had made adjustments to the JC-4 to
> increase its vacuum, but I can't seem to find it. So being brave I took it
> apart
> and found a small circuit board with an electronic sensor for vacuum. The
> board is mounted with the components against the housing, but there appears
> to be a surface mount IC and a power FET to drive the motor. I had posted
> a link to the operation of the JC-4 recently. From that document I'm sure
> the IC is likely a microcontroller, so making modifications to its
> operation is not really feasible.
>
> My next step is to wire directly to the motor to see how much vacuum it
> can actually pull. Unfortunately the case has a rubber seal which has
> swollen
> in length so is impossible to re-use. I'll need to find something to
> replace the seal before I can test it.
>
> I'll post my findings. If it can produce some decent vacuum, I can use
> something like a Superior K058 adjustable vacuum switch and a relay to
> control
> it.
>
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|