Re: [GMCnet] parking brake route [message #327651 is a reply to message #327650] |
Mon, 01 January 2018 17:26 |
cadelec
Messages: 303 Registered: September 2011 Location: Brisbane Australia
Karma:
|
Senior Member |
|
|
hi peter
i was planing on using pulleys the previous owner had at one time set up an electric actuator using a seat motor
i doubt if i used this i could get it passed through a roadworthy so this is why i want to go the original equipment as much as possible.
but i am sure pullys will be acceptable.
the PO has placed some pulleys on the outside of the rails at the front where the cables go thru them i hope to retain these but they are homemade and may not be suitable as they may not have a big enough lip.
if these dont work i will source some from the local trailer supply people
Trevor
Brisbane Australia
Siesta Koala 76 Edgemont (old Bobby Moores)
71 Cadillac Eldo Convert
58 Cadillac Eldorado Brougham Project
|
|
|