GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] 2 interesting topics. Warming up your engine before leaving the drive. Piston travel.
Re: [GMCnet] 2 interesting topics. Warming up your engine before leaving the drive. Piston travel. [message #327001 is a reply to message #326995] Mon, 11 December 2017 10:18 Go to previous messageGo to previous message
jimk is currently offline  jimk   United States
Messages: 6734
Registered: July 2006
Location: Belmont, CA
Karma:
Senior Member
It is all about setting the choke.
Too much is not good either.
Ray, I feel your procedure is good as it is better on the lean side during
choke mode.

On Mon, Dec 11, 2017 at 6:08 AM, Ray Erspamer wrote:

> Absolutely! Thank you. My techniques has been.....start it up, let it
> fast idle for a minute....and if the choke is set right it will either go
> and
> cough....if it coughs I let it warm up a bit more. If it pulls steady I
> drive it without abusing it.
> --
> Ray Erspamer
> 78 GMC Royale
> 414-484-9431
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>



--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org



Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Transmission vacuum modulator leaking?
Next Topic: Re: [GMCnet] Any experience with Lock and Lube Grease coupler?
Goto Forum:
  


Current Time: Fri Apr 19 23:22:36 CDT 2024

Total time taken to generate the page: 0.00911 seconds