Re: [GMCnet] K&N / Edelbrock Air Filter? [message #326323 is a reply to message #326321] |
Fri, 24 November 2017 22:34 |
jimk
Messages: 6734 Registered: July 2006 Location: Belmont, CA
Karma:
|
Senior Member |
|
|
When we use to race, we used sometimes metal filters coated with oil.
Without filters the air around the carb would not get pulled in in a semi
Laminar fashion and made a difference.
So we made it a rule to change oil after racing to cut down on wear from
the abrasive particulates.
Oil filters filter only 25% as the engine RPM is high and the pressure at
the filter is high enough for the bypass to open majority of the time.
Racing filters had lower restriction, but it did not filter smaller
particulets.
On Fri, Nov 24, 2017 at 6:37 PM, Ernest Dankert
wrote:
> It would be an interesting experiment to use a K+N as a pre filter to a
> paper filter and
> see how much "passed by".
>
> If I could be convinced to use a K+N I would perform an oil analysis and
> watch the Si (silicon)
> level like a hawk.
> --
> 1977 Eleganza II
> Ogden NY
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|