Re: [GMCnet] Fan? [message #325986 is a reply to message #325985] |
Tue, 14 November 2017 00:46 |
powerjon
Messages: 2446 Registered: January 2004
Karma:
|
Senior Member |
|
|
The fan motor is a part# PM102 at you're friendly AutoZone Parts store. Just a little under $20. You will have to R&R the squire cage between the two motor. After that it is a 10 minute job like Ken says. Don’t cut any wires!
JR Wright
> On Nov 14, 2017, at 1:01 AM, Ken Burton wrote:
>
> Just unplug the wire from the connector. I reused that wire to power my added vacuum pump for the brakes. If you cut it and later you decide you
> want to use it, you will have to put some kind if connector back on it. So why not just leave the connector on it and tape it up.
>
> On the noisy motor, Only 4 screws and one wire connection hold it in. Itis a 10 minute job to replace it. The last one I replaced was in an Autozone
> parking lot in Fallon, NV. Autozone had the new one in stock. 10 or 15 minutes and I was on my way.
> --
> Ken Burton - N9KB
> 76 Palm Beach
> Hebron, Indiana
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
J.R. Wright
GMC GreatLaker
GMC Eastern States
GMCMI
78 30' Buskirk Stretch
75 Avion Under Reconstruction
Michigan
|
|
|