Home » Public Forums » GMCnet » Rear Wheel Seal
| Re: [GMCnet] Rear Wheel Seal [message #325504 is a reply to message #325492] |
Sun, 29 October 2017 07:43  |
Bruce Hart
Messages: 1500
Registered: October 2011
Location: La Grange, Wyoming
Karma:
|
Senior Member |
|
|
Thanks Bruce, I made a plate for pressing the seal in that left the seal
proud by .060". I did converse with Dave L. and advised me that the seal
lip needed to
have at least 1/16" gap between lip and inner bearing race when installed.
On Sat, Oct 28, 2017 at 7:01 AM, Bruce Hislop wrote:
> Maybe the attached profile drawing will help. I believe Ken Henderson sent
> me this.
>
> http://www.gmcmhphotos.com/photos/skf-21771-rear-seal-
> fails-test/p63893-rear-axle-seal.html
>
> I think there maybe one more step or a taper on the axle at the seal area.
> The profile of the seal lip has been moved closer to the bearing so pushing
> the seal in too far causes it not contact the axle.
>
> Note: I am no professional degrees in any field therefore I have no
> knowledge about anything. Take my postings with a grain of salt.
>
> --
> Bruce Hislop
> ON Canada
> 77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
> Hubler 1 ton front end
> http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
> My Staff says I never listen to them, or something like that
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
--
Bruce Hart
1976 Palm Beach
Milliken, Co
GMC=Got More Class
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Bruce Hart
1976 Palm Beach
1977 28' Kingsley
La Grange, Wyoming
|
|
|
|
Current Time: Sun May 19 13:38:30 CDT 2024
Total time taken to generate the page: 0.00429 seconds
|
GMCforum
Search
Help
Register
Login
Home
