Home » Public Forums » GMCnet » Rear Wheel Seal
| Re: [GMCnet] Rear Wheel Seal [message #325406 is a reply to message #325405] |
Tue, 24 October 2017 22:07   |
 |
Cesar Carrasco
Messages: 30
Registered: September 2017
Location: Riverside, California
Karma:
|
Member |
|
|
Can anyone send a picture of the seal setting tool and the installed seal?
Please.
Sent from my iPhone
> On Oct 24, 2017, at 7:47 PM, Larry wrote:
>
> Ken Henderson wrote on Tue, 24 October 2017 12:04
>> Larry,
>>
>> It's my understanding that the front wheel seal should be proud also -- but
>> I never found a spec. for it in a manual. When we did one here recently I
>> made a seating tool to set 0.040", and arbitrary amount which seemed
>> adequate. Do you know the correct setting?
>>
>> I THINK I'd already made a tool for the rear seals; I'll have to hunt it up
>> and make sure it's set to your 0.060". If not, I'll chuck the disc back in
>> the lathe and correct it. What I'm a little concerned about there, though,
>> is whether the seal will then clear Manny's reaction arm torque box. So
>> many possible "gotcha's"! :)
>>
>> Ken H.
>>
>>
>>> On Tue, Oct 24, 2017 at 11:55 AM, Larry wrote:
>>>
>>> Seal should stand "proud" about .060.
>>> --
>>>
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
> Ken, I took that ".060 proud" off of the "set" tool that Dave makes. But still cannot remember what the setting is for the front seals. Betch-a Dave
> knows...
> --
> Larry
> 78 Royale w/500 Caddy
> Menomonie, WI.
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|
|
Current Time: Sun May 19 12:47:28 CDT 2024
Total time taken to generate the page: 0.00599 seconds
|
GMCforum
Search
Help
Register
Login
Home
