Larry,

It's my understanding that the front wheel seal should be proud also -- but
I never found a spec. for it in a manual. When we did one here recently I
made a seating tool to set 0.040", and arbitrary amount which seemed
adequate. Do you know the correct setting?

I THINK I'd already made a tool for the rear seals; I'll have to hunt it up
and make sure it's set to your 0.060". If not, I'll chuck the disc back in
the lathe and correct it. What I'm a little concerned about there, though,
is whether the seal will then clear Manny's reaction arm torque box. So
many possible "gotcha's"!

Ken H.


On Tue, Oct 24, 2017 at 11:55 AM, Larry wrote:

> Seal should stand "proud" about .060.
> --
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org