Re: [GMCnet] Engine Pre Lube Tank [message #325261 is a reply to message #325240] |
Sat, 21 October 2017 14:04 |
Chris Tyler
Messages: 458 Registered: September 2013 Location: Odessa FL
Karma:
|
Senior Member |
|
|
On many modern engines you have no choice but to use something like this. [LS1 for example]
Also, there are some engines that either won't build pressure or perhaps lose psi to the lifter gallery without part of the distributor to block it
I cant speak to Olds engines specifically though.
An old stripped distinutor with the cam gear ground off works well.
If you tee it off the oil presssure sender, its proabaly faster than pulling and retiming the distributor.
I agree that you can make one for much less [much like the brake bleeder that was discussed]
76 Glenbrook
[Updated on: Sat, 21 October 2017 14:06] Report message to a moderator
|
|
|