GMCforum: GMCnet » Oil Filter Sandwich Plate O-Ring

Home » Public Forums » GMCnet » Oil Filter Sandwich Plate O-Ring

Show: Today's Messages :: Polls :: Message Navigator

Re: Oil Filter Sandwich Plate O-Ring [message #324934 is a reply to message #324891]

Sat, 14 October 2017 08:27

tgeiger

Messages: 518
Registered: February 2006
Location: kansas city

Karma:

Senior Member

Ok, went thru this during the beginning of the summer and re-used a rubber gasket that was there. If I remember right, this gasket was more square and seemed to fit into a channel in the flange plate. Am I remembering right? So then I guess my question is , do I just add this o-ring between the flanges and then bolt it together with the filter stem sleeve bolt?

Tom Geiger 76 Eleganza II KCMO

Report message to a moderator

[Message index]

		Oil Filter Sandwich Plate O-Ring By: Ray Erspamer on Fri, 13 October 2017 08:15
		Re: Oil Filter Sandwich Plate O-Ring By: Jp Benson on Fri, 13 October 2017 08:33
		Re: Oil Filter Sandwich Plate O-Ring By: Ray Erspamer on Fri, 13 October 2017 21:46
		Re: Oil Filter Sandwich Plate O-Ring By: Ken Burton on Fri, 13 October 2017 22:53
		Re: Oil Filter Sandwich Plate O-Ring By: C Boyd on Fri, 13 October 2017 08:34
		Re: [GMCnet] Oil Filter Sandwich Plate O-Ring By: powerjon on Fri, 13 October 2017 08:38
		Re: Oil Filter Sandwich Plate O-Ring By: Ray Erspamer on Fri, 13 October 2017 08:40
		Re: Oil Filter Sandwich Plate O-Ring By: Larry on Sat, 14 October 2017 07:36
		Re: Oil Filter Sandwich Plate O-Ring By: tgeiger on Sat, 14 October 2017 08:27
		Re: [GMCnet] Oil Filter Sandwich Plate O-Ring By: bdub on Sat, 14 October 2017 10:02
		Re: Oil Filter Sandwich Plate O-Ring By: JohnL455 on Sat, 14 October 2017 08:46
		Re: Oil Filter Sandwich Plate O-Ring By: Larry on Sun, 15 October 2017 10:27
		Re: [GMCnet] Oil Filter Sandwich Plate O-Ring By: USAussie on Sun, 15 October 2017 16:35

Previous Topic:	[GMCnet] 2nd last cylinder doesn't receive spark
Next Topic:	Picture of a mounted Ragusa air scoop please.

Goto Forum:

-=] Back to Top [=-

Current Time: Fri May 17 15:24:20 CDT 2024

Total time taken to generate the page: 0.00559 seconds