GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Experience fixing quad airbag mounts?
Re: [GMCnet] Experience fixing quad airbag mounts? [message #324841 is a reply to message #324828] Wed, 11 October 2017 22:14 Go to previous messageGo to previous message
jimk is currently offline  jimk   United States
Messages: 6734
Registered: July 2006
Location: Belmont, CA
Karma:
Senior Member
I would like to see a picture of your 4 bag unit.
I believe it must be the Harrison unit.
Should that be our Quadra bag, we will replace it n/c as we have never had
a failure.

On Wed, Oct 11, 2017 at 1:22 PM, Shane Grass wrote:

> Hello fellow GMCers,
>>
>> I planned on introducing myself and my wife, Katherine, on better terms,
> but unfortunately I’m asking for advice following a breakdown in our
> recently acquired ‘76 Royale. To make a long story short, we’re in
> Watkinsville, GA headed black to Ocala, FL and I noticed a slight listing
> on the right rear suspension during a stop. I pulled the skirt and saw
> that the inner bottom weld of the support bracket has separated from the
> bogie and the inner bracket beneath the pin and the entire bracket has
> rotated about 30 degree outboard - bending, but not breaking the outer weld
> beneath the rotating pin, if that makes sense.
>>
>> Bottom line, we’re fortunate that we’re only 40 miles from the GMC
> specialists at Southland Motorhome and RV in Buford, GA. Thank goodness we
> have FMCA tow insurance and only have to pay $250 rather than $1000 for a
> Landoll since it’s not drivable. The tow truck is enroute and I’ll speak
> with the techs again in the morning. Looks to me like rust along the seam
> may have weakened the weld?
>>
>> Anyone out there had any similar experience? Just wondering how “bad”
> it will be. On the bright side, we put over 3000 miles on it driving from
> FL up the East coast and we almost mad it back to Ocala! Lol!
>
>> Resending this after realizing the message size limit. Hopefully my
> terminology is good enough to visualize without the photo I tried to attach.
>>
>> Thanks!
>>
>> Shane Grass
>> 831-402-5576
>>
>> Sent from my iPad
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>



--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org


Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Power Steering Pump Pulley
Next Topic: [GMCnet] Correct transmission fluid
Goto Forum:
  


Current Time: Tue May 14 05:43:43 CDT 2024

Total time taken to generate the page: 0.01259 seconds