GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Newby Question - Repack Rear Wheel Bearing - '73 - 26" (How To : Repack Rear Wheel Bearing - '73 - 26")
Re: [GMCnet] Newby Question - Repack Rear Wheel Bearing - '73 - 26" [message #323839 is a reply to message #323834] Wed, 13 September 2017 11:22 Go to previous messageGo to previous message
USAussie is currently offline  USAussie   United States
Messages: 15912
Registered: July 2007
Location: Sydney, Australia
Karma:
Senior Member
G'day,

I copied this from MM X-7525

BRAKE DRUM INSTALLATION

1. Install hub and drum assembly (figure 10).

2. Install flat washer and castillated nut on hub while rotating hub and drum assembly.

3. Tighten castillated nut to 25-30 lbs. ft. torque to position bearings. (Be sure drum is rotating while tightening nut).

4. Back off nut 1/2 turn.

5. Retighten nut finger tight, secure if possible with cotter pin.

6. If unable to secure at finger tight, back off nut to first securing position.

7. Check end play between hub and spindle it should be .001 to .005 inch.

8. Replace inner and outer dust caps.

Regards,
Rob M.
The Pedantic Mechanic
Sydney, Australia
AUS '75 Avion - The Blue Streak TZE365V100428
USA '75 Avion - Double Trouble TZE365V100426
USA '77 Kingsley - TZE 267V100808



_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org



Regards, Rob M. (USAussie) The Pedantic Mechanic Sydney, Australia '75 Avion - AUS - The Blue Streak TZE365V100428 '75 Avion - USA - Double Trouble TZE365V100426
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message icon14.gif
Read Message
Read Message
Previous Topic: Different Onan manual
Next Topic: [GMCnet] Smoke Detectors and CO2 Alarm placement
Goto Forum:
  


Current Time: Mon Apr 29 10:19:02 CDT 2024

Total time taken to generate the page: 0.03980 seconds