[GMCnet] No spark on HEI UPDATE [message #323802] |
Tue, 12 September 2017 15:05 |
Gary Worobec
Messages: 867 Registered: May 2005
Karma:
|
Senior Member |
|
|
Yes it was the ignition module, changed it out and fired right up. It did not go bad during operation but must have failed during startup from the last time I shut the motor down (several months ago) to when i tried to start it over the weekend.
The replacement that I got was from NAPA . 7 pin Echlin Part # TP47 supposedly for a 1982 Camaro 350. Dick Paterson indicated an 81 or 82 so he was spot on. Cost was $47.00. On the box it says Made in USA. Not sure if that is the box or what was in the box. Only difference was on the heat sink material supplied. Dick Paterson uses a white pasty material and the new one comes with a clear “silicone” looking stuff.
thanks everyone for their comments and replies.
Gary Worobec
1973 Glacier 23
Anza, CA
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|