GMCforum: GMCnet » Wire Labeling

Home » Public Forums » GMCnet » Wire Labeling

Show: Today's Messages :: Polls :: Message Navigator

Wire Labeling [message #323268]

Sun, 03 September 2017 20:31

JShot

Messages: 485
Registered: October 2006
Location: NW Ohio

Karma:

Senior Member

So, here's a question regarding what some of us have done, but maybe some of the newbies might not know.

When labeling wires, under hood, dash, wherever,

do you label both ends, or just one?

do you label each end where that wire comes from, or where it is going?

do you label each end with a number, presumably with the same number on each end, and then write down in a 'book' where the wire goes and comes from, its color and size?

Just wondering what everyone does...

John

John Shotwell
Ridgeville Corners, OH
78 Royale Center Kitchen

Report message to a moderator

[Message index]

		Wire Labeling By: JShot on Sun, 03 September 2017 20:31
		Re: Wire Labeling By: Ken Burton on Sun, 03 September 2017 20:46
		Re: Wire Labeling By: kerry pinkerton on Sun, 03 September 2017 21:50
		Re: [GMCnet] Wire Labeling By: Richard Denney on Mon, 04 September 2017 08:59
		Re: [GMCnet] Wire Labeling By: James Hupy on Mon, 04 September 2017 09:15

Previous Topic:	[GMCnet] Gray and black water tank readings
Next Topic:	As my jouney continues.... That frikken power loss problem on Gatsbys' Cruiser

Goto Forum:

-=] Back to Top [=-

Current Time: Wed May 08 10:31:01 CDT 2024

Total time taken to generate the page: 0.01854 seconds