Re: Fuel Gauge/Sender Question [message #322954 is a reply to message #322928] |
Tue, 29 August 2017 15:57 |
jhbridges
Messages: 8412 Registered: May 2011 Location: Braselton ga
Karma:
|
Senior Member |
|
|
You can also use a pair of Mr Gasket pumps, which have built in check valves. If you use them, do not use the supplied inlet filters, which are known to fail and leak. Replace them with the identical Wix filters. Here's one install:
http://www.gmcmhphotos.com/photos/g6198-cane-9-creek-rv-park-heflin-2c-al.html
That's a piece of 3/32 steel stock cut to fit across the frame anbd crosspiece, with the pumps and relay mounted. The mechanical pump is blocked off and a barbed fitting screwed onto the hard line going to the carb. If you have a mechanical [pump in your spares, you can convert to stock beside the road in maybe 30 minutes. No lines were cut, although some hose was added to the pump outlets.
--johnny
Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
I forgive them all, save those who hurt the dogs. They must answer to me in hell
|
|
|