| Re: [GMCnet] Mismatched Heads Again [message #322712 is a reply to message #322711] |
Sat, 26 August 2017 22:56   |
jimk
Messages: 6734
Registered: July 2006
Location: Belmont, CA
Karma:
|
Senior Member |
|
|
Ok, Most machine shops have a low paid young guy doing the heads. I always
request that the usual tech work on it and pay accordingly.
On Sat, Aug 26, 2017 at 8:48 PM, Carl Stouffer wrote:
> Jim, These were good cores with hardened valve seats. Larry's engine &
> Marine (Tucson) put them together with new SS valves, guides, and springs.
> They had been milled about .010. The new gaskets were thicker than that
> plus the stock metal gaskets.
> --
> Carl Stouffer
> '75 ex Palm Beach
> Tucson, AZ.
> Chuck Aulgur Reaction Arm Disc Brakes, Quadrabags, 3.70 LSD final drive,
> Lenzi knuckles/hubs, Dodge Truck 16" X 8" front wheels, Rear American
> Eagles,
> Solar battery charging. GMCSJ and GMCMI member
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
