Re: [GMCnet] Final Drive Intermediate Axle questions [message #323824 is a reply to message #322565] |
Tue, 12 September 2017 23:06 |
Richard Denney
Messages: 920 Registered: April 2010
Karma:
|
Senior Member |
|
|
The replacement shaft arrived today, and I did a quick visual comparison.
The previous bracket is subtly not square with the shaft, and will not only
push the shaft in too far, but will also hold the bearing at not quite
right angle to the shaft, which may be binding it. I won't be able to
install it until Thursday, but I do see differences that would explain the
issue. It would be very difficult to see the issue with the bracket unless
looking for that specific issue.
Rick "nor Thursday" Denney
On Wed, Aug 23, 2017 at 5:18 PM Richard Denney wrote:
> Yes. That would solve the spacing, but not any misalignment. I need to
> figure out which is happening, but I think I'll try the replacement Manny
> is sending first.
>
> Rick "not a lot of time to research this all the way" Denney
>
> --
> '73 X-Glacier 230 "Jaws"
> Northern Virginia
> Offlist email: rick at rickdenney dot com
>
--
Rick Denney
73 x-Glacier 230 "Jaws"
Off-list email to rick at rickdenney dot com
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|