Re: [GMCnet] Final Drive Intermediate Axle questions [message #322540 is a reply to message #322539] |
Wed, 23 August 2017 11:02 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
Well, I managed to screw that up: I left out the dimension "
The distance from the center of the outboard bolt to the inboard side of
the bearing bracket" is 3/4".
Ken H.
On Wed, Aug 23, 2017 at 11:54 AM, Ken Henderson
wrote:
> Rick,
>
> Here's the photo:
> https://drive.google.com/file/d/0B3XquSIYjDleN2cydTlUMGpaZl9ka
> EdfNUZ2TklKQ3lCanA0/view?usp=sharing
>
> Notice that the hex heads are parallel, so I measured 7-7/8" side to
> same-side of those.
>
> The distance from the center of the outboard bolt to the inboard side of
> the bearing bracket. Both of those, like the photo, are from-the-creeper
> since the rack's preoccupied with a guest.
> ...
>
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|