Re: [GMCnet] Final Drive Intermediate Axle questions [message #322539 is a reply to message #322538] |
Wed, 23 August 2017 10:54 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
Rick,
Here's the photo:
https://drive.google.com/file/d/0B3XquSIYjDleN2cydTlUMGpaZl9kaEdfNUZ2TklKQ3lCanA0/view?usp=sharing
Notice that the hex heads are parallel, so I measured 7-7/8" side to
same-side of those. The distance from the center of the outboard bolt to
the inboard side of the bearing bracket. Both of those, like the photo,
are from-the-creeper since the rack's preoccupied with a guest.
As Gary noted, the Eldorado's bracket has a tab to bolt the brace to; your
Olds' probably does not -- like the parts list you found.
Was I you, I'd probably probably bend the 90* on one end of a piece of bar
stock "just too long for the job", and bolt the brace to the bracket. At
the FD end I'd clamp it in place with a C-clamp for trouble shooting. If I
found a position that cured the problem, I'd mark and drill, cut, and bolt
the brace in that position. And hope.
JWID,
Ken H.
PS: When are you Phorum guys gonna go back to the practice of trimming
the threads before posting? Us eMailers wind up with umpty-lebn copies of
every reply when you don't. We do need a tidbit to remind us of what the
conversation was though. KH
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|