| Re: [GMCnet] Engine water temp sender location. [message #322337 is a reply to message #322336] |
Sat, 19 August 2017 10:21   |
James Hupy
Messages: 6806
Registered: May 2010
Karma:
|
Senior Member |
|
|
In your case, there shouldn't be much difference if the port is near the
top radiator hose. For me, the stock location, as well as the stock gage
works just fine. The stock gage is known to be only an approximate wild
assed guess, but that seems good enough for my needs. A high mileage 403,
well broken in, doesn't make enough heat to worry about for me. But, if you
have a tight 455 with great compression, and some head and block milling
done, your needs might be different than mine.
Jim Hupy
On Aug 19, 2017 8:10 AM, "Scott Nutter" wrote:
> Thanks Jim
> The rad port is right next to the water inlet uptop on the rad.
>
> If it was yours, where would you mount it?
>
> Thanks, scott
> --
> Scott Nutter
> 1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final
> drive, Quad bags, tankless water heater, everything Lenzi.
> Houston, Texas
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
