GMCforum: GMCnet » starting the engine

Home » Public Forums » GMCnet » starting the engine

Show: Today's Messages :: Polls :: Message Navigator

Re: [GMCnet] starting the engine [message #321709 is a reply to message #321707]

Sun, 06 August 2017 14:51

James Hupy

Messages: 6806
Registered: May 2010

Karma:

Senior Member

Kelly, pretty sure that your choke is not set properly. You could turn the
key on and listen for an electric fuel pump to run. That would fill the
carburetor float bowl with fuel if an electric pump were present. If no
pump, it won't accomplish much, EXCEPT WHEN YOU HAVE AN ELECTRIC CHOKE PULL
OFF. If you have an electric choke pull off, and you turn the ignition on,
and the choke is wired so it comes on with the key, it will open the choke
prematurely.
Assuming that you DON'T HAVE an electric fuel pump, and that your
electric choke is wired from the alternator so that it does not open
prematurely, the starting process should go something like the following.
Insert key into ignition.
Press down slightly on the throttle ONE TIME ONLY. This will set the
choke.
With your foot off the throttle, turn the key to start. Engine should
crank over and start and run on fast idle without stalling. It should start
within 10 - 15 seconds of cranking.
IF NO START, something is not correct.
Jim Hupy
Salem, Or
78 GMC ROYALE 403

On Aug 6, 2017 12:27 PM, "kelly stockwell" wrote:

> I am pretty sure I do, and the PO replaced it just before I got it.
>
> He mentioned putting in a new fuel pump for me hoping it would stop any
> vapor lock issues. As far as I can tell I've not had that.
>
> Is there an easy way for me to tell?
> --
> 1978 Kingsley
> Putney VT
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

[Message index]

		starting the engine By: kstockwell on Sun, 06 August 2017 13:55
		Re: starting the engine By: shaunone on Sun, 06 August 2017 14:18
		Re: starting the engine By: kstockwell on Sun, 06 August 2017 14:26
		Re: starting the engine By: Carl S. on Sun, 06 August 2017 14:49
		Re: [GMCnet] starting the engine By: James Hupy on Sun, 06 August 2017 14:51
		Re: [GMCnet] starting the engine By: kstockwell on Sun, 06 August 2017 20:16
		Re: [GMCnet] starting the engine By: k2gkk on Sun, 06 August 2017 20:25
		Re: [GMCnet] starting the engine By: kstockwell on Sun, 06 August 2017 20:38
		Re: [GMCnet] starting the engine By: k2gkk on Sun, 06 August 2017 22:24
		Re: [GMCnet] starting the engine By: Richard Denney on Sun, 06 August 2017 22:57
		Re: starting the engine By: mrgmc3 on Sun, 06 August 2017 23:15
		Re: [GMCnet] starting the engine By: ljdavick on Mon, 07 August 2017 01:14
		Re: starting the engine By: Chris Tyler on Mon, 07 August 2017 04:24
		Re: [GMCnet] starting the engine By: Bruce Hart on Mon, 07 August 2017 06:13
		Re: [GMCnet] starting the engine By: kstockwell on Mon, 07 August 2017 07:15
		Re: starting the engine By: JohnL455 on Mon, 07 August 2017 08:56
		Re: starting the engine By: kstockwell on Sun, 13 August 2017 14:11
		Re: starting the engine By: kstockwell on Sun, 13 August 2017 14:35
		Re: [GMCnet] starting the engine By: Keith V on Mon, 14 August 2017 09:00
		Re: [GMCnet] starting the engine By: kstockwell on Mon, 14 August 2017 14:45
		Re: [GMCnet] starting the engine By: Keith V on Mon, 14 August 2017 15:20
		Re: [GMCnet] starting the engine By: kstockwell on Mon, 14 August 2017 18:00
		Re: [GMCnet] starting the engine By: 77Royale on Mon, 14 August 2017 15:34
		Re: [GMCnet] starting the engine By: kstockwell on Mon, 14 August 2017 18:25
		Re: [GMCnet] starting the engine By: k2gkk on Mon, 14 August 2017 16:21
		Re: [GMCnet] starting the engine By: kstockwell on Mon, 14 August 2017 18:02
		Re: [GMCnet] starting the engine By: k2gkk on Mon, 14 August 2017 20:35
		Re: [GMCnet] starting the engine By: Keith V on Tue, 15 August 2017 08:43
		Re: starting the engine By: JohnL455 on Tue, 15 August 2017 08:44
		Re: [GMCnet] starting the engine By: bdub on Tue, 15 August 2017 09:23
		Re: [GMCnet] starting the engine By: kstockwell on Wed, 16 August 2017 06:14
		Re: [GMCnet] starting the engine By: kstockwell on Wed, 16 August 2017 06:18
		Re: [GMCnet] starting the engine By: Richard Denney on Wed, 16 August 2017 07:03
		Re: [GMCnet] starting the engine By: USAussie on Wed, 16 August 2017 07:19
		Re: [GMCnet] starting the engine By: kstockwell on Wed, 16 August 2017 08:16
		Re: starting the engine By: jhbridges on Tue, 15 August 2017 11:05
		Re: starting the engine By: 77Royale on Wed, 16 August 2017 07:27
		Re: starting the engine By: kstockwell on Wed, 16 August 2017 19:17
		Re: starting the engine By: jhbridges on Thu, 17 August 2017 08:15
		Re: starting the engine By: kstockwell on Thu, 17 August 2017 10:11
		Re: [GMCnet] starting the engine By: James Hupy on Thu, 17 August 2017 10:26
		Re: [GMCnet] starting the engine By: jimk on Thu, 17 August 2017 11:02
		Re: [GMCnet] starting the engine By: kstockwell on Thu, 17 August 2017 11:29
		Re: [GMCnet] starting the engine By: kstockwell on Thu, 17 August 2017 17:35
		Re: [GMCnet] starting the engine By: James Hupy on Thu, 17 August 2017 18:00
		Re: [GMCnet] starting the engine By: kstockwell on Thu, 17 August 2017 18:19
		Re: [GMCnet] starting the engine By: James Hupy on Thu, 17 August 2017 18:25
		Re: [GMCnet] starting the engine By: kstockwell on Thu, 17 August 2017 18:35
		Re: [GMCnet] starting the engine By: kstockwell on Thu, 17 August 2017 18:34
		Re: [GMCnet] starting the engine By: kstockwell on Sun, 20 August 2017 08:05
		Re: [GMCnet] starting the engine By: James Hupy on Sun, 20 August 2017 09:00
		Re: [GMCnet] starting the engine By: kstockwell on Sun, 20 August 2017 09:29
		Re: starting the engine By: kstockwell on Sat, 19 August 2017 15:16
		Re: starting the engine By: C Boyd on Sat, 19 August 2017 19:00
		Re: starting the engine By: kstockwell on Sun, 20 August 2017 07:42

Previous Topic:	[GMCnet] Oil sputtering (4K) Onan
Next Topic:	Re: [GMCnet] Whitch speedometer fits in 1975 GMC Motor home

Goto Forum:

-=] Back to Top [=-

Current Time: Thu May 30 22:33:11 CDT 2024

Total time taken to generate the page: 0.95295 seconds