GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » New Owner Questions
Re: [GMCnet] New Owner Questions [message #320469 is a reply to message #320455] Sat, 15 July 2017 08:02 Go to previous messageGo to previous message
USAussie is currently offline  USAussie   United States
Messages: 15912
Registered: July 2007
Location: Sydney, Australia
Karma:
Senior Member
Hal,

I'm sorry but I am going to disagree with you; it is not a flimsy frame, the lower horizontal cross section of the "[" frame rails
were not designed to be jacked under.

Maintenance Manual X-7525 / Section Index 0 - General Information / Pages 0-2 through 0-4 provide clear instructions how and where
to jack the coach.

Whenever I see a frame rail that has a lower horizontal cross section that is bent upwards I know that was caused by someone that
didn't read the MM.

Ragusa (http://www.ragusarv.com/) makes a neat tool to hang the wheels on the studs:

RV-09 Wheel Lifter Bar $29.00 ea

This lever bar allows you to lift heavy tires by placing the lifter into the center hole of wheel and over 4" dust cap. Lift wheel
and rotate to locate studs.

Regards,
Rob M.
Sydney, Australia
AUS '75 Avion - The Blue Streak TZE365V100428
USA '75 Avion - Double Trouble TZE365V100426
USA '77 Kingsley - TZE 267V100808

-----Original Message-----
From: Gmclist [mailto:gmclist-bounces@list.gmcnet.org] On Behalf Of Hal StClair
Sent: Saturday, July 15, 2017 1:47 PM
To: gmclist@list.gmcnet.org
Subject: Re: [GMCnet] New Owner Questions

Be careful rotating the tires as most shops don't understand where the lift points are and jacking in the wrong places will cause
damage to the flimsy frame. It's really a simple job to do yourself doing one side at a time. Using a pair of jacks (or a single
jack if that's all you have) and jack stands or blocking for safety, lift one side at a time. Nothing complex at all, just a bit
heavy especially if you have steel wheels. I've gotten so I use a pry bar to position the wheels into place anymore. Just gettin old
I guess.
Hal
--


_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org



Regards, Rob M. (USAussie) The Pedantic Mechanic Sydney, Australia '75 Avion - AUS - The Blue Streak TZE365V100428 '75 Avion - USA - Double Trouble TZE365V100426
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Our GMC handled 80 mph side winds better then I thought last night.
Next Topic: Couple more newbie questions
Goto Forum:
  


Current Time: Wed May 15 12:22:22 CDT 2024

Total time taken to generate the page: 0.01087 seconds