GMCforum: GMCnet » Wanted dinette seat

Home » Public Forums » GMCnet » Wanted dinette seat

Show: Today's Messages :: Polls :: Message Navigator

Re: Wanted dinette seat [message #316941 is a reply to message #316939]

Mon, 01 May 2017 20:40

A Hamilto

Messages: 4508
Registered: April 2011

Karma:

Senior Member

Hal StClair wrote on Mon, 01 May 2017 20:14

I'm looking for half of a GM built dinette, the front half on the curb side or the rear half on the street side.
Thank you, Hal

If you are talking about the foam cushions on plywood cases, build them. Trivially simple if you have a sabresaw and 3/4" plywood and some hardwood to make cleats. Any upholstery shop can make the covers for the foam cushions.

If you need the "contact paper" that covers them to match your interior, I can't help.

I had to replace the back of one that had been water damaged. I cut it with a table saw. Even the curved part.

I can give you detailed measurements and pictures.

The angle brackets come from your big box store. The angle steel that attaches the back to the aisle side of the base is the only thing you have to get cut to length and holes drilled.

Report message to a moderator

[Message index]

		Wanted dinette seat By: Hal StClair on Mon, 01 May 2017 20:14
		Re: Wanted dinette seat By: A Hamilto on Mon, 01 May 2017 20:40
		Re: Wanted dinette seat By: Hal StClair on Mon, 01 May 2017 20:45
		Re: Wanted dinette seat By: NextGenGMC on Wed, 03 January 2018 16:31
		Re: Wanted dinette seat By: C Boyd on Tue, 02 May 2017 06:12

Previous Topic:	[GMCnet] Can antifreeze/water freeze solid, and do damage at -25 when tested to +5?
Next Topic:	[GMCnet] Fwd: Free Radiatior internal camera inspection, with radiator/cap pressure test.

Goto Forum:

-=] Back to Top [=-

Current Time: Sat May 18 23:42:44 CDT 2024

Total time taken to generate the page: 0.00698 seconds