GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » onan plugs and wires
Re: onan plugs and wires [message #314703 is a reply to message #314690] Thu, 16 March 2017 08:20 Go to previous messageGo to previous message
Ken Burton is currently offline  Ken Burton   United States
Messages: 10030
Registered: January 2004
Location: Hebron, Indiana
Karma:
Senior Member
The Autozone near me has all kinds of single wires in stock at $6.59. Get 2, cut them to length, and install. They have both 7mm and 8mm diameter wires in stock.

Or visit your local junk yard and grab a few probably for free.

Be sure to be check them for continuity before installing. Especially on used ones. The readings should be a few thousand ohms and different depending on length. After they are installed read them again from one spark plug wire end to the other spark plug wire end. Again there needs to be continuity and the reading should be approximately the sum of the two readings that you took of each wire before.


Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] 11 hour drive Wed. New Chinese electric fuel pump shut us down in Talsa Ok.
Next Topic: [GMCnet] carter electric fuel pump
Goto Forum:
  


Current Time: Fri May 17 01:29:28 CDT 2024

Total time taken to generate the page: 0.00972 seconds