GMCforum: GMCnet » [GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts.

Home » Public Forums » GMCnet » [GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts.

Show: Today's Messages :: Polls :: Message Navigator

Re: [GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts. [message #310077 is a reply to message #310056]

Tue, 08 November 2016 08:50

Chris Tyler

Messages: 458
Registered: September 2013
Location: Odessa FL

Karma:

Senior Member

I always loved the 'works in the drawer' Onans.
Most SOBs did not have them. A few had swing down mounts which made service and removal easier, but you couldn't run them tilted
ours are much easier to work on.

Speaking of which, helped a friend tear down an oman Marquis 7.0 that was locked up. FAR more involved. Plenty of FU bolts.
turned out to be the pulley end motor bearing fragged.

76 Glenbrook

Report message to a moderator

[Message index]

		[GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts. By: BobDunahugh on Mon, 07 November 2016 19:05
		Re: [GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts. By: tphipps on Mon, 07 November 2016 19:41
		Re: [GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts. By: JohnL455 on Mon, 07 November 2016 22:35
		Re: [GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts. By: JohnL455 on Mon, 07 November 2016 22:39
		Re: [GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts. By: Chris Tyler on Tue, 08 November 2016 08:50
		Re: [GMCnet] Pulling the 6000w Owan. Are you kiding me. Just 8 -1/4 inch bolts. By: SeanKidd on Tue, 08 November 2016 10:30

Previous Topic:	Norcold refrigerator install
Next Topic:	[GMCnet] 3 Ton Jack

Goto Forum:

-=] Back to Top [=-

Current Time: Sun May 26 23:47:43 CDT 2024

Total time taken to generate the page: 0.97242 seconds