Re: [GMCnet] Pitman arm nut removal [message #301218 is a reply to message #301209] |
Fri, 27 May 2016 22:34 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
On center??? Were I faced with using an impact wrench to remove a pitman
arm nut, I"d turn the steering wheel all the way to the left, so that the
entire steering system would be "grounded" in the CCW direction. That way
the impacts from the wrench would be passed through as few "delicate" parts
as possible. After the nut's broken loose, then return the steering to
center.
JWID,
Ken H.
On Fri, May 27, 2016 at 10:18 PM, John R. Lebetski
wrote:
> Be sure it's on center--- of course.
> --
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|