Re: [GMCnet] Left exhaust manifold donut gasket [message #283492 is a reply to message #283490] |
Wed, 29 July 2015 18:58 |
Dennis S
Messages: 3046 Registered: November 2005
Karma:
|
Senior Member |
|
|
Mike
In my experience the donuts needed to be rotated and also tighten the three studs progressively to achieve a good seal.
Dennis
powerjon wrote on Wed, 29 July 2015 18:39Mike,
You DO NOT have to remove the exhaust manifold from the engine to change the donut out. Spray the bolts or studs at the exhaust manifold outlet with PB Blaster or similar and the remove them. The exhaust system will drop down enough to replace the donut. Put back together and drive on.
If you have the original Onan fuel pump the filter is in the bottom which will unscrew 1/4 to 1/2 turn, it has a screen inside and a rubber o-ring as a seal.
J.R. Wright
GMC Great Laker MHC
GMC Eastern States
GMCGL Tech Editor
GMCMHI
78 GMC Buskirk 30' Stretch
1975 GMC Avion (Under Reconstruction)
Michigan
> On Jul 29, 2015, at 7:17 PM, Thomas Mike wrote:
>
> Hello, I'm 800 miles from home in New England with big left side donut gasket leak. Has anyone ever changed their donut without removing the exhaust
> manifold. I have a donut but don't want to risk breaking manifold bolts that were last removed over 5 years ago. Hope the exhaust flange bolts don't
> break.
>
> Also, is there a fuel filter for the onan 6000? Having fuel issues with tanks verified more then half full. I see the fuel pump and what I think is a
> check valve but no fuel filter.
>
> Thanks
> --
> Mike Thomas
> Troy, MI
> 77 ex Palm Beach, 77 Royale (rear bath)
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Dennis S
73 Painted Desert 230
Memphis TN Metro
|
|
|