It's been too damn cold to do much lately. Kills my motivation when its 18 degrees outside.
I did get the shower pan built.
I had to do it twice because the first one I forgot to offset the drain hole by 1/2". Whoops. Good thing I've got plenty of walnut sitting around haha.

Design in cad so the water all drains:
http://www.thegmcrv.com/wp-content/uploads/2017/03/Capture.jpg

Cut and glue:
http://www.thegmcrv.com/wp-content/uploads/2017/03/IMG_20170221_173703756-1336x1002.jpg

Send through the widebelt to flatten it out, then a skim pass on the CNC to get it perfectly flat on the bottom. Flip it over and:

http://www.thegmcrv.com/wp-content/uploads/2017/03/IMG_20170311_142915720-1336x1002.jpg

And 4 hours later

http://www.thegmcrv.com/wp-content/uploads/2017/03/IMG_20170311_170550159-1336x1002.jpg

Switch to the ballnose bit and wait another 5 hours:
http://www.thegmcrv.com/wp-content/uploads/2017/03/IMG_20170311_183538301-1336x1002.jpg

Back to the 1/2" endmill and we're done
http://www.thegmcrv.com/wp-content/uploads/2017/03/IMG_20170311_183857197-1336x1002.jpg

And this is where it goes, tile is up next to cover all the redcoat
http://www.thegmcrv.com/wp-content/uploads/2017/03/IMG_20170302_183417614-1336x1002.jpg

All the walnut needs to be sanded and finished as well.