Re: Aluminum black tank [message #280924 is a reply to message #280903] |
Sun, 28 June 2015 15:52 |
jhbridges
Messages: 8412 Registered: May 2011 Location: Braselton ga
Karma:
|
Senior Member |
|
|
I figure when my black tank dies (installed by Norris, I expect it's a 'standard' size) beyond the ability of me and the nasty black epoxy which has held fine so far, I'll take some thin stainless over to my welder bud's shop and see if I can't bend one up on his press brake or his hand brake. Then he can weld it around the seams and add flanges as necessary. I haven't had a lot of success bending 90s in aluminum.
--johnny
Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
I forgive them all, save those who hurt the dogs. They must answer to me in hell
|
|
|