GMCforum: GMCnet » Steering intermediate rod not parallel with front frame

Home » Public Forums » GMCnet » Steering intermediate rod not parallel with front frame

Show: Today's Messages :: Polls :: Message Navigator

Re: Steering intermediate rod not parallel with front frame [message #277304 is a reply to message #277167]

Tue, 05 May 2015 07:57

RF_Burns

Messages: 2276
Registered: June 2008
Location: S. Ontario, Canada

Karma:

Senior Member

Chuck,
I can see moving washers would help, but there is not enough washers to move it far enough (more than 3/8" difference end to end)

Adjust ride height will do nothing in my case as the relay and idler are fixed to the front cross-member. I am wondering is my cross-member is twisted or is the bracket for relay arm bent?

Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that

Report message to a moderator

[Message index]

		Steering intermediate rod not parallel with front frame By: RF_Burns on Sun, 03 May 2015 14:41
		Re: Steering intermediate rod not parallel with front frame By: C Boyd on Sun, 03 May 2015 20:56
		Re: Steering intermediate rod not parallel with front frame By: RF_Burns on Tue, 05 May 2015 07:57

Previous Topic:	Front calipers...again
Next Topic:	Silicone fluid for rear ride height control valves

Goto Forum:

-=] Back to Top [=-

Current Time: Mon May 13 03:24:11 CDT 2024

Total time taken to generate the page: 0.19831 seconds