Re: [GMCnet] block off plates [message #208765 is a reply to message #208764] |
Sat, 25 May 2013 12:09 |
C Boyd
Messages: 2629 Registered: April 2006
Karma:
|
Senior Member |
|
|
Sir: I would suggest a good small pry bar such as a lady finger. Try to pry on non gasket areas. Do not drive a screw driver between a gasket area. If you have to, drive a thin putty knife to break seal. Might use a razor knife to cut the ends.
Kathy and Fred Estabr wrote on Sat, 25 May 2013 12:41 | Help! I am in a world of hurt. Installed Springfield exhaust block off
plates and I guess one of the gaskets moved enough on installation that I
have a major water leak . The black RTV has now set so hard that I can't
get the manifold off. Any suggestions ??
Fred Estabrook
76 Ell
Florence AZ
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
C. Boyd
76 Crestmont
East Tennessee
|
|
|