Re: [GMCnet] 1/2" tank vent steel tube source needed. [message #167851 is a reply to message #167792] |
Sat, 28 April 2012 01:07 |
Chuck Garton
Messages: 54 Registered: June 2006
Karma:
|
Member |
|
|
Yes. Mine was set up that way before the third tank went in.
Chuck
On Fri, Apr 27, 2012 at 3:24 PM, Rob Mueller <robmueller@iinet.net.au> wrote:
> Chuck,
>
> THANKS! Since you have three 3/8" vent lines dumping into the 1/2" vent line
> without any problems it is safe to assume that two will work fine too!
>
> Regards,
> Rob M.
>
> -----Original Message-----
> From: Chuck Garton
>
> Rob,
>
> Most of the time, I can use the high setting. I understand when the
> gas station puts new filters in the lines, one gets a faster flow,
> dirty filters flow is slower.
>
> I have experienced no need to stop and burp.
>
> I do get a splash out of the filler if I let get full at the high
> setting. I usually calculate how much gas it take to get 10 MPG and
> when that number comes up, I go to the slow setting. This avoids
> splash back. My 13,500 lb coach gets a steady 8 MPG.
>
> Chuck
>
> On Fri, Apr 27, 2012 at 1:54 AM, Rob Mueller <robmueller@iinet.net.au>
> wrote:
>> Chuck,
>>
>> Thanks for commenting and proving that my memory is not as bad as I think
> it
>> is and I'm not getting senile - YET! ;-)
>>
>> I would appreciate some more details about when you refuel.
>>
>> 1) Can you set the fuel filler nozzle at the highest position and the
> tanks
>> fill without it shutting off?
>>
>> 2) Do you have to stop to let the tanks burp?
>>
>> 3) When you get close to full is there any spray back out of the fuel
> filler
>> on the GMC?
>>
>> Regards,
>> Rob M.
>>
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|