Re: [GMCnet] 1/2" tank vent steel tube source needed. [message #167792 is a reply to message #167790] |
Fri, 27 April 2012 17:24 |
|
USAussie
Messages: 15912 Registered: July 2007 Location: Sydney, Australia
Karma:
|
Senior Member |
|
|
Chuck,
THANKS! Since you have three 3/8" vent lines dumping into the 1/2" vent line
without any problems it is safe to assume that two will work fine too!
Regards,
Rob M.
-----Original Message-----
From: Chuck Garton
Rob,
Most of the time, I can use the high setting. I understand when the
gas station puts new filters in the lines, one gets a faster flow,
dirty filters flow is slower.
I have experienced no need to stop and burp.
I do get a splash out of the filler if I let get full at the high
setting. I usually calculate how much gas it take to get 10 MPG and
when that number comes up, I go to the slow setting. This avoids
splash back. My 13,500 lb coach gets a steady 8 MPG.
Chuck
On Fri, Apr 27, 2012 at 1:54 AM, Rob Mueller <robmueller@iinet.net.au>
wrote:
> Chuck,
>
> Thanks for commenting and proving that my memory is not as bad as I think
it
> is and I'm not getting senile - YET! ;-)
>
> I would appreciate some more details about when you refuel.
>
> 1) Can you set the fuel filler nozzle at the highest position and the
tanks
> fill without it shutting off?
>
> 2) Do you have to stop to let the tanks burp?
>
> 3) When you get close to full is there any spray back out of the fuel
filler
> on the GMC?
>
> Regards,
> Rob M.
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Regards,
Rob M. (USAussie)
The Pedantic Mechanic
Sydney, Australia
'75 Avion - AUS - The Blue Streak TZE365V100428
'75 Avion - USA - Double Trouble TZE365V100426
|
|
|