Re: 1/2" tank vent steel tube source needed. [message #167773 is a reply to message #167673] |
Fri, 27 April 2012 13:55 |
midlf
Messages: 2212 Registered: July 2007 Location: SE Wisc. (Palmyra)
Karma:
|
Senior Member |
|
|
midlf wrote on Thu, 26 April 2012 21:15 | I need to find a source for the 1/2" steel tubing used as the tank fill vent line between the tanks and the front of the frame. This tube is similar to the standard 3/8" steel fuel line.
Is this stuff that hard to find or am I not asking for the right product or calling the right places?
|
Well duh - I solved the problem. I was poking around this AM on the design for the new fuel system and found my original drawings that I had forgotten about. (no comments needed, I already know what that means.) The new fuel venting system needs separate lines up to just below the filler and 3/8" lines will work just fine. Thanks for the input.
Steve Southworth
1974 Glacier TZE064V100150 (for workin on)
1975 Transmode TZE365V100394 (parts & spares)
Palmyra WI
|
|
|