Re: [GMCnet] 1/2" tank vent steel tube source needed. [message #167728 is a reply to message #167701] |
Fri, 27 April 2012 08:11 |
midlf
Messages: 2212 Registered: July 2007 Location: SE Wisc. (Palmyra)
Karma:
|
Senior Member |
|
|
Robert Mueller wrote on Thu, 26 April 2012 23:09 | Steve,
OK, I interpret the manual to mean that the vent lines are 3/8" ID rubber
from the tank fuel level sender to the solid tubes #40 and the "T" #38.
IIRC on Double Trouble these lines were rubber.
Regards,
Rob M.
|
Correct.
I gave thought to the double 3/8" lines but prefer to go the original way. I think, that if done correctly, I.E. no kinks or other restrictions, it will work properly.
Steve Southworth
1974 Glacier TZE064V100150 (for workin on)
1975 Transmode TZE365V100394 (parts & spares)
Palmyra WI
|
|
|